Splash resistance tester factory from China
Excellent synthetic blood penetration tester factory? Universal testing machine (also known as tensile testing machine) that performs tensile, compression, flexure, peel, tear, shear, friction, and other types of mechanical testing in accordance with ASTM, ISO, and other industry standards. GESTER Abrasion Tester Professional manufacturer, providing a full range of solutions, Martindale Abrasion Tester in line with ASTM, ISO and other standard requirements, factory direct sales. Discover extra information at synthetic blood penetration test equipment.
Pneumatic Bursting Strength Testing Machine For determining the bursting strength of woven or knitted fabrics, non-woven, paper, leather and board by application of a pneumatic load under a rubber diaphragm of a specific area. Provide with a digital readout of pressure with peak value hold facility, renewable rubber diaphragms, and manual clamping device with acrylic bell, forward reverse and neutral drive system. Provide accurate elongation information of fabrics, up to 0.1mm.
The power must be turned off when going to work. Basic functions of utm wholesale universal tensile testing machine: tensile properties, tensile strength and deformation rate, tensile strength, tear resistance, heat sealing strength performance, roller peeling test, 90 degree peeling, rope breaking force, pants tear Force, 180 degree peeling, compression test, bending test, shear test, burst test, etc. to complete different tests, according to customer needs, can install different fixtures, wide specimen fixtures, etc.
Testing to ASTM D4060 involves mounting a flat specimen to a turntable that rotates horizontally at a fixed speed. Two arms, each supporting an abrading wheel, are then lowered so that each wheel touches the surface. Before starting the test, a “suction arm” is lowered between the wheels to remove the abraded material from the sample’s surface. The turntable then starts rotating forcing rub-wear action of the wheels against the sample’s surface for the specified number of cycles or until a given mass of coating has been lost or until the wheels start exposing the substrate.
Equip with procedure time counter, digital temperature controller, auto temperature & time control, it has alarm hint while experiment ending.Can customize cup compound mode according to customers requirements. Samples Preparation: Place the samples and multi-fiber adjacent fabric under the constant temperature and humidity (temperature: 21±1℃, humidity: 65%±3%) for 4 hours. Cut 40mm*100mm specimen and multi-fiber adjacent fabric, and suture the specimen and multi-fiber adjacent fabric face to face along one short side. Discover more information on https://www.gesterinstruments.com/.